Q: My toilet seat has plastic bolts that keep coming loose, making the seat wobble and very uncomfortable to sit on. I keep tightening the nuts, but they work loose quickly. Can you help? --L. James
A: Toilet seats often wobble because the holes in the toilet-bowl rim are larger than the diameter of the bolts, allowing movement that eventually makes the nuts loose. Tightening the nuts seldom works very well. There are a several possible solutions.
One is to buy a kit containing rubber or plastic bushings that fit over the top of the bolt, filling the space around the bolt and preventing the motion.
These kits are sold at some home centers and on the internet for less than $5 (search the Internet for Bushings for Wobbly Toilet Seat).
Digital Access for only $0.99
For the most comprehensive local coverage, subscribe today.
Another approach is to install self-adhesive rubber washers between the lid and top of the toilet bowl. For more information on washers, go to www.yukonseatgrip.com (about $3 for a set of washers).
If you have an old bicycle inner tube or piece of sheet rubber, make your own washers by cutting a hole in a the middle of a small piece and slip it over each bolt before re-installing the lid. Another do-it-yourself approach: Wrap a little plumber's Teflon tape around the threads of each bolt before tightening the nuts, improving the grip of the nuts.
A last resort is to put a little glue on the threads before tightening the nuts; use glue designed to hold plastics.
If glue is used, however, it might be necessary to use a hacksaw or power tool to cut through the bolts if you want to replace the lid.
Q: I want to install two frameless mirrors above a bathroom vanity. However, I am concerned about them falling down because the brackets are supposed to be located on the sides. Do you have any thoughts on this? --Connie
A: It is usually best to follow manufacturer's directions when installing any product. Using alternate methods of installation could invalidate any warranty that might be offered.
If you follow instructions and have a problem, the manufacturer should help you solve it.
However, manufacturers are not always right. The evidence for this includes the frequent recalls of unsafe products and crackdowns by the Consumer Products Safety Commission.
If you have doubts about the method of installation, the best bet is to contact the customer service department of the manufacturer and discuss it. I don't know the weight of these mirrors, but some frameless mirror installations call for putting brackets under the bottom edge, which in my opinion is the best way to support the weight.
Brackets are also often placed over the top edge, to prevent tilting forward. Some frameless mirrors are glued in place, which gives a good bond but makes the mirrors difficult and even dangerous to remove.
If you contact the manufacturer and still have safety concerns, it might be wise to return these mirrors to the dealer and look for more satisfactory replacements.
* Questions and comments should be emailed to Gene Austin at gaus17aol.com.